JNJ-64326067 是一种具有血脑屏障穿透性的聚集型 tau 蛋白结合剂(Ki 为 2.4 nM),可选择性结合聚集型 tau 蛋白而不结合聚集型 β-淀粉样蛋白,且对受试受体、离子通道、转运体、激酶或单胺氧化酶无显著脱靶结合,可用于阿尔茨海默病的研究。
产品编号: MS-Y14054 CAS No.: 2173357-28-1 分子式: C15H12FN3 分子量: 253.28
MolStrong 的所有产品仅用作科学研究或药证申报,我们不为任何个人用途提供产品和服务
规格 价格 是否有货 数量 购物车
5mg
询价
询价
10mg
询价
询价
25mg
询价
询价
50mg
询价
询价
100mg
询价
询价
200mg
询价
询价
500mg
询价
询价

产品描述

JNJ-64326067 是一种具有血脑屏障穿透性的聚集型 tau 蛋白结合剂(Ki 为 2.4 nM),可选择性结合聚集型 tau 蛋白而不结合聚集型 β-淀粉样蛋白,且对受试受体、离子通道、转运体、激酶或单胺氧化酶无显著脱靶结合,可用于阿尔茨海默病的研究。

生物实验数据

生物活性 JNJ-64326067 is a blood-brain barrier-penetrant aggregated tau protein binder with a Ki of 2.4 nM that selectively binds aggregated tau protein without binding aggregated β-amyloid and shows no significant off-target binding to tested receptors, ion channels, transporters, kinases, or monoamine oxidases, and can be used for research on Alzheimer's disease.
体外研究
(In Vitro)

[3H]JNJ-64326067 和 [18F]JNJ-64326067 可特异性结合死后人类 AD 脑切片中的 tau 病理,而不结合仅存在 Aβ 的病理,且这种结合可被非放射性 JNJ-64326067 选择性阻断。
JNJ-64326067 具备适合穿透中枢神经系统的理化性质,无显著的 MDR1 介导外排作用,在血浆和脑组织中的游离比例较低,且在大鼠、猴和人肝细胞微粒体及肝细胞中具有较高的固有清除率。

体内研究
(In Vivo)

JNJ-64326067 (0.03 mg/kg;静脉注射;单次给药) 在健康雄性 Sprague-Dawley 大鼠中表现出快速的血浆清除率、较短的血浆半衰期以及良好的脑暴露水平,其皮层与血浆的比值为 4.0。
JNJ-64326067 (1-10 mg/kg;皮下注射;静脉注射;单次给药) 在健康雌性 Wistar 大鼠中表现出较高的初始脑摄取率、快速清除率,且未检测到脱靶结合;其骨摄取情况表明存在体内脱氟作用。
JNJ-64326067 (1 mg/kg;静脉注射;单剂量;与[18F]9 注射同时进行) 在健康雄性恒河猴中表现出脑摄取量高、清除迅速、脑内分布均匀且无骨摄取的特征,阻断研究显示,由于进入脑部的示踪剂可利用性提升,其峰值摄取量有所增加。

Animal Model: Sprague-Dawley (male)
Dosage: 0.03 mg/kg
Administration: i.v.; single dose
Result: Exhibited a plasma clearance of 228 mL/min/kg.
Showed a plasma half-life of 0.08 h.
Reached a plasma AUC of 2.2 ng·h/mL.
Reached a cortex AUC of 8.72 ng·h/mL.
Had a volume of distribution at steady state (Vd,ss) of 1.6 L/kg.
Achieved a cortex-to-plasma ratio (Kp) of 4.0.
Had an estimated unbound brain-to-plasma ratio (Kp,uu) of 1.1.
Animal Model: Wistar (female)
Dosage: 10 mg/kg (pretreatment); 1 mg/kg (displacement)
Administration: s.c.; single dose, 60 minutes pre [18F]9 injection; i.v.; single dose, 30 minutes post [18F]9 injection
Result: Showed high initial brain uptake (SUV of 2.4 at 1 minute post-injection).
Underwent rapid brain washout (SUV of 0.2 at 60 minutes post-injection).
Did not reduce time-activity curve intensity with pretreatment and displacement, indicating no reversible or irreversible off-target specific binding.
Caused bone uptake at later time points, suggesting in vivo defluorination.
Animal Model: male
Dosage: 1 mg/kg
Administration: i.v.; single dose; simultaneous with [18F]9 injection
Result: Showed high brain uptake (SUV of 5.4 in whole brain, time to peak uptake: 4.5 minutes) with rapid washout.
Had homogeneous distribution across brain regions, with lower uptake in the corpus callosum and skull.
Showed no bone uptake up to 120 minutes post-injection.
Had a higher peak whole brain SUV of 7.5 in blocking study, with shorter time to peak (3.5 minutes) and slightly faster washout, and no pronounced blocking effect was observed.

化学信息

分子量 253.28
分子式 C15H12FN3
CAS No. 2173357-28-1

储存&溶解度

储存方式

Please store the product under the recommended conditions in the Certificate of Analysis.

运输条件 Room temperature in continental US; may vary elsewhere.

计算器

质量 (mg) = 浓度 (mM) x 体积 (mL) x 分子摩尔量 (g/mol)
Mass (g) = Concentration (mol/L) × Volume (L) × Molecular Weight (g/mol)
起始浓度(M)× 起始体积(L)= 最终浓度(M)× 最终体积(L)
Concentration (start) × Volume (start) = Concentration (final) × Volume (final)
This equation is commonly abbreviated as: C1V1 = C2V2
溶液体积 = 质量 ÷ 配液浓度
Volume (to add to vial) = Mass (in vial) ÷ Desired Reconstitution Concentration
÷
分子量计算器
Enter the chemical formula of the compound to calculate its molar mass and elemental composition
g/mol

体内实验配液计算器

动物实验计算换算器

请在以下方框中输入您的动物实验信息后点击计算,可以得到母液配置方法和体内配方的制备方法:

比如您的给药剂量是10 mg/kg,每只动物体重20 g,给药体积100 μL, 一共给药动物10只,您使用的配方为 10% DMSO + 40% PEG300 + 5% Tween 80 + 45% Saline / PBS / ddH2O, 那么您的工作液浓度为2 mg/mL。

母液配置方法:2 mg 药物溶于 100 μL DMSO ( 母液浓度为 20 mg/mL ), 如您需要配置的浓度超过该产品的溶解度,请先与我们联系。

体内配方的制备方法: 取 100 μL DMSO 母液, 添加 400 μL PEG300 混匀澄清, 再加 50 μL Tween 80, 混匀澄清, 再加 450 μL Saline / PBS / ddH2O 混匀澄清

以上为“体内实验配液计算器”的使用方法举例,并不是具体某个化合物的推荐配制方式,请根据您的实验动物和给药方式选择适当的溶解方案。

方案所需的各类助溶剂如: DMSO, PEG300, PEG400, Tween 80, SBE-β-CD, 玉米油等, 均可在MolStrong网站点击购买。

第一步:请输入基本实验信息(考虑到实验过程中的损耗,建议多配一只动物的药量)
第二步:请输入动物体内配方组成(配方适用于不溶于水的药物;不同批次药物配方比例不同,请联系客服为您提供正确的澄清溶液配方)
+
+
+

计算结果:

工作液浓度: mg/ml;

DMSO母液配制方法: mg 药物溶于 μL DMSO溶液(母液浓度 mg/mL,

体内配方配制方法:取 μL DMSO母液,加入 μL PEG300,混匀澄清后加入μL Tween 80,混匀澄清后加入 μL Saline/PBS/ddH2O,混匀澄清。

1. 首先保证母液是澄清的;
           2. 一定要按照顺序依次将溶剂加入,进行下一步操作之前必须保证上一步操作得到的是澄清的溶液,可采用涡旋、超声或水浴加热等物理方法助溶。

开始您的科研之旅

20,0000+ 种高纯度分子化合物,专业靶点数据库,全程技术支持
让每一个实验数据都有坚实的分子基础